When a Commonwealth Act commences
What this covers
This article covers three rules from Part 3 of the Acts Interpretation Act 1901 (Cth). These rules tell a student when an Act commences if it says nothing, what a stated commencement day means, and what powers can be used before an Act commences.
The Act applies to all Acts, including itself. A Note to s 2(1) says it also applies to legislative instruments, notifiable instruments and other instruments, through s 13(1) of the Legislation Act 2003 (Cth) and s 46(1) of the Acts Interpretation Act.
This article only explains the rules for Acts. It does not explain how these rules work for instruments, and it says nothing about State or Territory law.
All of this is “subject to a contrary intention” under s 2(2). This means the stated rules apply only if nothing else indicates a different intention.
The elements
If a Commonwealth Act is silent on timing, it commences 28 days after Royal Assent. Royal Assent is when the Act is formally approved. The count runs from assent, not from when Parliament passed it.
This default rule gives way if the Act says when it commences, but only “so far as” it does so. So if an Act fixes a start date for some provisions but not others, the default still fills the gap for the rest.
Acts altering the Constitution are different: they commence on the day of Royal Assent itself.
When a commencement day is set, the Act or provision starts “at the start of the day”. This applies whether the Act says “come into operation” or “commence”. So it is in force for that whole day, not from a later moment.
How it works in practice
Work through commencement questions in order. First check if the Act sets its own commencement date, because s 3A(1) controls when it applies. If the Act says nothing about a provision, use the default rule: the 28th day after assent under s 3A(2), or the day of assent under s 3A(3) if the Act alters the Constitution.
Once you have an answer, convert it to an actual date. A stated day begins at its very start.
This order matters because one Act can use both sources. Some provisions commence under the Act’s own section; others, not covered there, fall back to the default. Stopping after checking the Act’s commencement section, without considering the default, is a mistake. So is skipping straight to the default without checking first.
Applying this in a problem question
Start with the specific provision, not the whole Act. Commencement can differ between provisions in the same Act.
Check the Act’s own commencement section first. Section 3A only applies if the Act does not already say when that provision commences.
If the Act is silent, use the default rule: commencement is the 28th day after assent. The exception is for Acts altering the Constitution, which commence on the day of assent itself.
Turn that into a date, and treat the provision as in force from the start of that day.
If the relevant facts happened before commencement, do not treat the provision as already operating. Instead check whether s 4 permitted the action: s 4(2) allows early exercise of a power, and s 4(3) allows preparatory acts.
Section 4(4) otherwise generally stops a provision from conferring a power or right, or imposing an obligation, before commencement. There is an exception where this is necessary or convenient for the stated purposes.
If an appointment or instrument was made early under s 4(2), s 4(5) decides when it actually takes effect. That is either at the commencement start time, or a later time that is specified.
Self-check
Before using the default rule, check the Act’s own commencement provision first.
Check whether that provision deals with the specific section you’re looking at. It may only address part of the Act, not the whole thing.
Use the correct default rule. This is 28 days after assent, or assent itself if the Act alters the Constitution. Don’t assume the 28-day rule applies whenever a provision is silent.
If something happened before commencement, keep enabling machinery separate from an imposed obligation. These are different things.
A Quick Read uses simpler language and may leave out detail, including whole topics, to stay short. The full article is the complete statement.