Commonwealth anti-discrimination Acts

No single national instrument

There is no single Act covering all discrimination law in Australia.

So you cannot answer “is this unlawful?” from one statute. The answer depends on three things: the attribute involved, the area of activity, and the jurisdiction.

A national employer may need to check both Commonwealth and State or Territory laws at once.

This is not a mistake. It reflects how Australian constitutional arrangements work. That is why the topic is taught as separate instruments, not one code.

The structure common to the Acts

These Acts share a common structure, even though they are separate statutes.

Each Act protects certain attributes, like race, sex, disability, or age. Related traits, such as pregnancy or marital status, may also be protected, depending on the Act.

Each Act also lists areas of public life where discrimination on these grounds is unlawful. These typically include employment, education, goods and services, accommodation, and access to premises.

Conduct outside these listed areas is not caught by the discrimination prohibitions, even if unfair. Always check the conduct falls within a covered area. Separate provisions, like victimisation provisions, might still apply though.

Finally, each Act sets up a complaint and conciliation process. This is run by the Australian Human Rights Commission, and a person generally must use it before going to court.

The Commission investigates complaints and tries to conciliate a resolution between the parties. Only if conciliation fails, or is inappropriate, can the matter proceed toward litigation.

Direct and indirect discrimination

Commonwealth Acts recognise two kinds of discrimination: direct and indirect.

Direct discrimination sometimes uses a comparator test. Section 5(1) of the Sex Discrimination Act asks whether a person was treated worse than someone else in similar circumstances, because of a protected attribute. Section 9(1) of the Racial Discrimination Act does not use a comparator; it looks at the purpose or effect of a race-based act instead.

The comparator test asks a causal question: was the treatment because of the attribute? IW v City of Perth (1997) 191 CLR 1 shows this question can be genuinely contested, especially where conduct linked to the attribute is itself disputed.

IW was decided under the Equal Opportunity Act 1984 (WA), as it stood in 1990 — not under a Commonwealth Act. That Act was later amended by the Equal Opportunity Amendment Act 1992 (WA), inserting s 66A(1a), effective from 8 January 1993. This extended impairment discrimination to cover less favourable treatment because of a relative or associate’s impairment. Dawson and Gaudron JJ said this amendment had no bearing on the outcome in IW.

Indirect discrimination, described here only in general terms, occurs when a requirement or condition applies equally to everyone, but disadvantages people who share a protected attribute. It is unlawful only if the requirement is not reasonable in the circumstances. The statutory tests differ, so the specific provision must be checked.

Section 5(2) of the Sex Discrimination Act and s 15 of the Age Discrimination Act refer to a condition, requirement or practice that has, or is likely to have, a disadvantaging effect on people of the same sex or age. Neither provision uses the words “applies to everyone equally”. Both extend to proposed requirements and to likely, not just actual, disadvantage.

Section 6 of the Disability Discrimination Act adds further conditions. It applies where a person with a disability cannot comply with the requirement because of that disability, or could only comply if reasonable adjustments were made.

Indirect discrimination targets rules that look neutral but cause unequal practical effects. For example, a requirement unrelated to an attribute on its face might still disadvantage a much higher proportion of people without that attribute.

Why this orients the module

Australia has no single Human Rights Act. So the rest of this module looks at the other parts of the patchwork, one by one.

These parts are: human rights charters and Acts in specific jurisdictions, proportionality reasoning (used to test limits on rights), and the indirect role of international human rights treaties in Australian law.

Each of these parts adds to the Commonwealth anti-discrimination Acts. None of them replaces those Acts.

Applying this in a problem question

First, work out which attribute is involved. Then check which Commonwealth Act, if any, protects that attribute.

Next, check the conduct fits the relevant prohibition, including any required area of activity. Also ask whether another provision, like victimisation, might apply too.

Then apply the right test. Direct discrimination means treating someone less favourably because of the attribute. Indirect discrimination means a neutral rule has a disproportionate, unreasonable effect. Under s 9 of the Racial Discrimination Act the test differs: ask whether a race-based act has the purpose or effect of nullifying or impairing a human right. Section 9(1A) sets its own separate conditions for requirements.

After that, check the Act for exceptions or exemptions that might apply to these facts.

Remember the procedure: a complaint usually goes to the Australian Human Rights Commission for conciliation first, before any court case.

Finally, consider whether State or Territory anti-discrimination law might also apply. Commonwealth coverage does not always cover everything.

A Quick Read uses simpler language and may leave out detail, including whole topics, to stay short. The full article is the complete statement.

Read the full article →

Pop quiz

5 quick questions on this article, the authorities it cites and the articles it links to.

  • About 3 minutes, and no time limit.
  • You can only go forwards: each answer locks when you submit it.
  • After each question you see the right answer, why, and where to read more.
  • Free, and no account needed. Log in or create a free account to keep your scores.